Replacing guides on a telescopic rod - Professional guide

Replacing the guides on a telescopic rod requires some patience and precision. This procedure is not exactly a routine operation and should be carried out carefully to preserve the structural integrity of the rod. However, sometimes it is worth investing a little effort and repairing the rod you have instead of buying a new one. We have a large selection of ceramic guides in our offer and they are currently on sale!

Follow this guide step by step.

1. Preparing the workspace

• Ensure a clean, well-lit work space
• Prepare all the necessary tools in advance:
  • Pointed tweezers
  • Mechanical hair dryer (with low temperature option)
  • Two-component adhesive
  • Medical alcohol 70%
  • Soft, lint-free cloths
  • Precision screwdriver set

2. Dismantling the rod

a) Initial inspection:

• Examine the rod closely to identify all connection points.
• Note the position of each guide.

b) Disassembly procedure:

1. Place the stick horizontally on a soft surface.
2. Unscrew the bottom cap (foot) counterclockwise
3. Separate each segment gradually:
   • Hold the segment firmly but without applying force.
   • Loosen the joint with light rotating movements (5-10°).
   • Avoid sudden withdrawal

3. Removing existing guides

a) Thermal loosening:

1. Set the mechanical hair dryer to 60-70°C.
2. Heat the area around the guide evenly for 15-20 seconds.
3. After warming up, wait 10 seconds before manipulating.

b) Extraction:

• Use tweezers to grasp the base of the guide.
• Apply an even pulling force along the rod axis.
• If necessary, use a scalpel, preferably sharp.

4. Preparing surfaces for the new guide

1. Clean the bearing surface thoroughly:
   • First remove deposits mechanically.
   • Then treat with alcohol
2. Check the bearing geometry:
   • The surface must be completely flat.
   • Eliminate any unevenness with fine sandpaper (600+ grit)

5. Installation of new guides

a) Positional alignment:

• Position the guide precisely
• Ensure perfect symmetry of all guides

b) Gluing process:

1. Apply a minimal amount of epoxy glue
2. Place the guide in the intended position.
3. Pay attention to:
   • Alignment angle
   • Installation depth
   • Even distribution of glue

6. Final processing and quality control

1. After installation, allow 24 hours for polymerization.
2. Carry out the check:
   • Visual inspection
   • Rotation test
   • Checking axial symmetry

For the final check:

• Perform a nylon line test with minimal load
• Check that the rod is folding and extending properly.

Safety notes:

• Never use heat above 80°C.
• Avoid using metal tools in direct contact with graphite parts
• If you are unsure of the procedure, contact an authorized service technician.

This professional approach ensures the long-term functionality of your telescopic rod and optimal fishing performance. Each step should be carried out with complete care and precision.